Site Loader

ECE132L – INSTRUMENTATION AND CONTROL LABORATOTYÒ

 

LABORATORY ACTIVITY #1

We Will Write a Custom Essay Specifically
For You For Only $13.90/page!


order now

F.A.C.E.T.
base unit/DC fundamentals circuit/DC Ammeter

 

Name: John Raymond A. Alla

Section: A38

Date: January 27, 2018

Laboratory Instructor: W.A. Deveza

 

I.            
Introduction

A.          
F.A.C.E.T. base
unit

The Manual Base
Unit contains a total of 32 Circuit Modification (CM) and fault switches.
Students manually select CM switches as the course progresses, while the
protected fault switches are reserved for Instructor use by means of an integrated,
locking-cover assembly.

The FACET base
units provide voltage supply with protection and conditioning circuitry to run
each FACET board

B.          
DC fundamentals
circuit

C.          
DC Ammeter

II.         
Discussion

A.          
F.A.C.E.T. base
unit

B.          
DC fundamentals
circuit

C.          
DC Ammeter

III.       
Conclusion

A.          
F.A.C.E.T. base
unit

a.                  
The DC FUNDAMENTALS
circuit board connects to the base unit with the         ZIF             connector.

b.                 
A CW rotation
opens the ZIF connector: a CCW rotation locks the ZIF      connector.

c.                  
To verify the
operation of the + 1OV control on the base unit, you can measure      the variable power source on the OHM’S LAW
circuit block of the DC FUNDAMENTALS
circuit board.

B.          
DC fundamentals
circuit

a.      
      LEDs become
brighter as more current f lows through a circuit.

 

b.     
      Apply power
to a circuit by placing a two-post connector between the energizing   test points in the circuit.

C.          
DC Ammeter

a.      
      A basic 1 mA
full-scale meter movement can be used as an ammeter.

 

b.     
      You can use
a shunt resistor to extend the range of a 1 mA meter movement to      indicate a 10 mA full-scale circuit
current.

IV.       
Unit test

 

            1.         The F.A.C.E T. base unit provides for
protection against

                        B. overvoltage,
overcurrent, and reverse power connection.

            2.         A student can alter the configuration
of circuit blocks by

                        C. using the
circuit modification switches on the base unit.

            3.         The DC FUNDAMENTALS circuit board s
property connected to the base unit when                  the

                        B. ZIF
connector knob is rotated In a CW direction

            4.         The
multi meter DC voltage function is selected by the

                        A. range switch

            5.         The
variable power source In the OHM’S LAW circuit block on the DC                                          FUNDAMENTALS circuit board is
adjusted by the

                        D. +15 Vdc control on the
power supply

            6. 
       On the DC FUNDAMENTALS circuit
board, test points separated by dashed lines can                be used to

                        C. energizes the associated circuit.

            7.         When
measuring circuit current, connect the ammeter

                        C. so all circuit current flows through
the ammeter.

            8.         An
arrow through a battery symbol Indicates

                        D. a variable source output

            9.         Is the symbol for a

                        B. light-emitting diode

            10.       The
term milliamperes abbreviated

                        A. mA

Post Author: admin

x

Hi!
I'm Erica!

Would you like to get a custom essay? How about receiving a customized one?

Check it out